Anschutz Gyro Compass Standard 20 Service Manual

The Anschütz Standard 20 features built-in self-test (BIST) routines. When a fault occurs, an error code appears on the display. Below are common faults and their typical solutions: Error Code / Symptom Potential Cause Recommended Action (Takes >5is greater than 5 hours to settle)

An electronic servo system that continuously realigns the outer sphere with the inner gyrosphere without physical contact, preventing frictional drag. Electronic and Distribution Units

Follow-up motor failure, broken drive belt, or amplifier fault.

Monitor the color-changing humidity indicator inside the housing casing. Replace the desiccant pack if it shows signs of moisture saturation. 4. Calibration and Alignment Adjustments anschutz gyro compass standard 20 service manual

The official is a comprehensive document organized into three major sections, as outlined in the manual’s table of contents:

The Standard 20 gyro compass is known for its high precision. The technical data section in the manual outlines the operational envelope, including:

Carefully lift the gyrosphere using the designated lifting tools. Place it on a soft, clean surface. Inspect the sphere surface for pitting, discoloration, or scratches. The Anschütz Standard 20 features built-in self-test (BIST)

: Speed and latitude are manually entered via the operator unit and transferred to all connected gyro compasses. It is obligatory to input actual speed and latitude data to ensure correct speed error calculation, including the correct north/south indication.

Reinstall the sphere. Fill the container with a precise mixture of distilled water and the proprietary Anschütz additive (anti-bacterial and conductivity fluid) to the indicated fill line. System Calibration and Correction Inputs

Switch off the master compass and the transmission unit. Allow the gyrosphere to settle completely (minimum 2 hours) and cool down. Place it on a soft

Used supporting fluid contains chemical additives and must be disposed of in accordance with MARPOL regulations and local environmental laws. Conclusion

If you need to execute specific diagnostic tests, let me know: The displayed on your control unit The current running hours of your gyrosphere

Inspection of the fluid and sphere performance.