Dvb01 User Manual Fix -
Setting up your DVB01 device is a straightforward process that requires minimal technical expertise. Here's a step-by-step guide to get you started:
| Specification | Value | | :--- | :--- | | | DVB01 | | Measurement Range | DC 0 - 100V | | Measurement Accuracy | ±0.1V | | Power Supply | 12V DC or 24V DC, depending on model variant | | Key Component | Industrial-grade microcontroller | | Display | 3-digit, 7-segment red digital tube | | Core Function | Voltage comparator with relay output | | Parameters | 4 settings (P-0 to P-3), automatically saved | | Hysteresis/Operating Modes | 5 pre-programmed functions (F-01 to F-05) |
: The relay contact remains shorted to the COM port during idle states. It breaks continuity when the relay triggers. 3. Function Modes Explained
Connect your electronics/load through the relay. If your battery drops too low, the DVB01 disconnects the load to protect the battery from permanent depletion damage. dvb01 user manual
: The relay pulls in (turns ON) when the measured voltage ( VIN ) stays between the Lower Limit (V2) and the Upper Limit (V1).
A: The DVB01 can measure direct voltage ranging from 0V to 100V.
Positive terminal for the module's operating power (5V, 12V, or 24V depending on your specific model). Setting up your DVB01 device is a straightforward
Check that the function chosen (F1-F5) matches your intent, and verify that the measured voltage is crossing the P₁/P₂ thresholds.
Use the button to alter the flashing digit value and the SWI button to advance to the next digit.
: DC 0.0V to 99.9V (±0.1V accuracy) Relay Output Capacity : Normally Open (NO) port: Max DC 30V/10A or AC 250V/10A Normally Closed (NC) port: Max DC 28V/10A or AC 125V/10A : The relay pulls in (turns ON) when
After completing the V1 values, the system automatically flashes V2 . Repeat the exact same button sequence to assign the numerical values for your lower voltage threshold.
A: Yes, it has an automatic power-saving function that can be set independently by the user.
Press and for 3 seconds. The screen will change to show the current function designation (e.g., F-1 ).
To program the unit, you will interact with the "SET," "+," and "-" buttons.
Before wiring the module, it is important to understand its electrical limitations and capabilities to avoid damaging the components.