1.8 meters to 3.0 meters (5.9 feet to 9.8 feet)
Uni-directional (Detects approaching motion only for energy saving) The Initialization Setup Run (Critical Step)
Use the manual adjustment screw to align the safety curtain. The safety field must look directly downward, passing immediately in front of the moving door leaf without hitting the door itself. 5. Setup and Calibration Routine
Fix: Disconnect the main power plug for 10 seconds to cycle power. If the code persists, the internal hardware may need replacement.
The inclination angle can be modified in 5° increments (0° to 40°), and the PCB can be turned horizontally (-35° to +35°) to refine the detection range. DIP Switch Settings: prosecure opti combi manual english
| Issue | Probable Cause | Recommended Solution | | :--- | :--- | :--- | | | E-Stop engaged; Air pressure low; Door open. | Release E-Stop; Check pressure regulator; Close safety guards. | | Inconsistent Fill Levels | Product supply pressure fluctuating; Worn nozzle seal. | Stabilize product pump pressure; Check/replace nozzle O-rings. | | Dripping Nozzle | Worn valve seals; Product viscosity too low. | Replace valve seals; Adjust shut-off timing on HMI. | | Caps not tightening | Incorrect torque setting; Worn cap gripper jaws. | Adjust torque via regulator; Replace gripper jaws. |
For electrical diagrams or specific part numbers, users must refer to the full schematic appendix provided in the original manufacturer's documentation.
: Infrared presence curtain is permanently blocked. Clean the lens or increase the angle away from the door leaf.
: Power Input (12-24V AC / 12-30V DC, non-polarized). Setup and Calibration Routine Fix: Disconnect the main
The ProSecure Opti Combi is a high-performance, dual-technology sensor used widely on automatic sliding doors. By combining microwave radar for motion detection (activation) with active infrared technology for presence detection (safety), it ensures compliant, reliable, and smooth door operations.
: Feed the multi-core connection cable through the rubber grommet on the rear panel. Strip back the wire jackets according to the system terminal block allocations.
The ProSecure Opti-Combi is a robust packaging solution designed for reliability and hygiene. Adherence to the procedures outlined in this report—specifically regarding the safety measures and daily cleaning cycles —is mandatory for safe operation. Regular maintenance of pneumatic parts and seals will ensure the machine retains its high efficiency and accuracy over its operational lifespan.
The sensor will map the floor surface and background. Once the LED stops flashing and turns solid green, the sensor is ready for normal operation. 6. LED Indicator Diagnostics and Troubleshooting DIP Switch Settings: | Issue | Probable Cause
The Prosecure Opti Combi serves two primary roles to ensure efficient and safe door operation:
The sensor must be connected to the door control unit. The following is a summary of the core wiring details found in the installation guide.
ProSecure Opti Combi Manual: Comprehensive Installation, Configuration, and Troubleshooting Guide
IP54 (suitable for external doors when protected from direct driving rain). Temperature Range: -20°C to +60°C (-4°F to 140°F). 2. Package Contents & Component Layout Before starting, verify you have all the necessary parts. What is in the Box 1 x ProSecure Opti Combi Sensor 1 x 3-meter Connection Cable 1 x Mounting Template (Drilling Guide) 2 x Mounting Screws 1 x English Instruction Leaflet Component Identification
Settings can be adjusted via an internal LCD display and navigation buttons (Red for switching, Black for selection).
The active infrared safety field is blocked (pedestrian or object detected in the threshold). Resetting to Factory Defaults