We use cookies to make your experience better. To comply with the new e-Privacy directive, we need to ask for your consent to set the cookies. Learn more.
Dual LED display showing PV (Measured Value) and SV (Set Value). Quick Operation Guide Setting the Temperature (SV):
Press and hold the front-panel hardware reset pinhole with a paperclip while switching the main power supply back on.
Use the key to select the digit you wish to change.
While the interface is "simple," the multi-functional nature of the unit can be overwhelming for beginners without a clear manual. xmtk-9000 user manual
When using the XMTK-9000, follow these safety precautions:
Selects between different thermocouples or RTD types. (e.g., 0 for K-type, 20 for Pt100).
If a system fault cannot be cleared using the troubleshooting matrix outlined above, contact your regional field application engineering support division. Please ensure you have your device serial number (located on the side barcode sticker) and the exact system log file exported to a USB drive ready before placing a service call. Dual LED display showing PV (Measured Value) and
Manufacturers periodically release firmware updates to optimize stability, patch security vulnerabilities, and introduce new functional features.
The XMTK-9000 features a sleek and compact design, with a user-friendly interface and a range of advanced features. The device consists of:
If you want, I can: generate a printable PDF formatted manual, adapt this guide for a specific confirmed feature list, or create step-by-step procedures for a particular measurement. While the interface is "simple," the multi-functional nature
| Problem | Likely Cause | Solution | |-----------------------------|----------------------------------|------------------------------------------| | No display, green LED off | No power or blown internal fuse | Check input voltage; replace fuse (T1A) | | Erratic input reading | Sensor wiring open or wrong type | Verify 4–20mA loop; set correct input mode | | Cannot change setpoint | PID loop not enabled | Enable loop in Control > PID Status | | Modbus no response | Wrong slave ID or baud rate | Reset to default using rear dipswitch 3 |
A: Contact technical support with your unit's serial number (found on the rear label). There is no hardware backdoor for security reasons.
The controller interface consists of a key and directional keys for parameter adjustment. Setting the Target Temperature (SV): Press the SET key once. The SV display will begin to flash.
The XMTK-9000 ships with a default static IP address configured from the factory.