Zte F689 Bridge Mode Exclusive

: Go to the Internet tab and select the WAN section.

Once the ZTE F689 restarts, it acts as a dedicated modem. Now you must configure your personal router to pick up the internet signal.

Here is the "exclusive" trick most guides miss: You cannot simply add a second rule. You must the existing routing rule before creating the bridge.

You will see a list of WAN connections. Look for the one named INTERNET , TR069 , or VOIP . zte f689 bridge mode exclusive

If you get in with Super Admin, the interface will look much more complex. Go to , and you will almost certainly have the ability to change the Mode to Bridge without restrictions.

Standard user logins (like user / user ) restrict access to WAN settings. You must use the administrator account. Common default credentials include: : admin or telecomadmin

Bridge Mode (and similar models like the F680 or F670L) is a popular but often restricted procedure. For most users, : Go to the Internet tab and select the WAN section

If your ISP uses , enter the username and password you saved from Step 1.

If your ISP uses , your router will automatically pull a public IP.

Unlike standard bridge mode (which often leaves one port active for a secondary router), the exclusive bridge mode on the ZTE F689 fully disables the router, DHCP, NAT, and Wi-Fi functionalities, converting the device into a pure, high-speed optical modem. It hands the public WAN IP directly to your high-performance router. Here is the "exclusive" trick most guides miss:

Power on the ZTE F689 and wait two minutes for the fiber lights to stabilize. Power on your personal router.

Disconnect all devices from the ZTE F689. Connect a single computer directly to of the ZTE unit using an Ethernet cable. Do not attempt this configuration over Wi-Fi. Step 2: Access the Gateway Admin Panel

Note: Once DHCP is disabled, your computer will lose its IP address. This is normal. Connecting Your Third-Party Router

ISPs often require a clean ARP table flush. Power down both devices for five full minutes, then boot the ZTE gateway completely before powering up your personal router.