If you turn off the ignition and exit the car without manually arming the alarm, the Cobra 3195 will automatically immobilize the engine after .
The LED will illuminate solid to confirm successful access to programming mode. Feature Selection Matrix
: If the system is disarmed but no door is opened within 120 seconds, it will automatically re-arm to prevent accidental disarming. Emergency PIN Override
This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.
Clean the bonnet pin switch contact surface with wire wool or spray it with a moisture repellent like WD-40. Replace the switch if it fails to rebound fully. cobra 3195 alarm manual full
To disable specific sensors (e.g., the tilt sensor if parked on a slope or volumetric sensors if pets are inside), use the smaller button on the remote: pressing it once disables one sensor, twice disables another, usually within 40 seconds of arming.
The Cobra 3195 belongs to the Globe 3100 series and is distinguished as a (auto alimentado), meaning it has its own backup battery. This is crucial for its operation. Below is a general pinout table for the system's main connector:
Once in programming mode, press the LED button to cycle through the selectable features: Passive Arming (ON / OFF)
The Cobra 3195 is designed to integrate seamlessly with a vehicle's electrical architecture. It combines perimeter protection, interior space monitoring, and engine immobilization into a single cohesive unit. If you turn off the ignition and exit
Press the on the remote once. The vehicle's dashboard LED will turn on for 2 seconds to confirm registration. Repeat steps 5 through 7 for any additional remotes. Turn the ignition OFF to exit programming mode. 5. Wiring Diagram and Installation Specifications
Enter your 4-digit emergency PIN code using the ignition/LED method outlined in Section 3.
The Cobra 3195 has an internal shock sensor (usually on the control module near the fuse box). The manual explains:
A door, bonnet, or boot pin switch is not fully compressed, or the interior dome light delay is too long. Emergency PIN Override This public link is valid
: Press the large button on the remote. The turn indicators flash twice and the LED begins to flash.
Press and hold Button B to trigger the siren manually in an emergency.
Local radio frequency interference from commercial towers, power grids, or wireless infrastructure.
