Discrimination filters out unwanted metal items like iron nails, tin foil, and pull-tabs.
Before assembling or operating your Orbitor Prospector 100, read these vital guidelines to protect your equipment and ensure personal safety.
Before heading out into the field, familiarize yourself with the structural and electronic capabilities of your device. 5.5 kHz – 6.5 kHz Search Coil: 6.5-inch weather-resistant concentric coil Audio System: Built-in speaker and 3.5mm headphone jack
One plastic wing nut, one threaded plastic bolt, and two rubber washers. User Manual: This reference documentation. Technical Specifications Operating Frequency: 5.5 kHz to 6.5 kHz Orbitor Prospector 100 Metal Detector Manual
: Push the connector pin through the aligned holes. Tighten the plastic fixing knob by hand.
The interface consists of simple knobs and an analog target meter. Understanding these controls is vital for separating valuable targets from iron trash.
: Features a Discrimination Mode to filter out unwanted items like iron or foil and an Adjustable Sensitivity Control to adapt to different soil conditions. Discrimination filters out unwanted metal items like iron
Before we begin assembly, let's look at the technical data. This part of the will help you understand the physical capabilities of your new device.
Elias laughed. Marketing in the seventies was weirdly intense.
Adjusts the signal amplification. Turn this up to maximize depth. Turn it down if you experience erratic false signals caused by highly mineralized soil or nearby electrical interference. Tighten the plastic fixing knob by hand
: Keep holding Reset . Adjust the Discrimination dial until the analog needle rests squarely in the center of the meter scale.
The Orbitor Prospector 100 Metal Detector Go to product viewer dialog for this item.
Walk slowly. You may be swinging over a piece of iron right next to a good target, causing the machine to balance out the signals. Try approaching the target from a different angle.
: Place the rubber washers into the lower stem groove.