Galaxy Aqua Premier Installation Manual Verified [ RELIABLE » ]

Connect the shower head to the hose. Make sure the rubber washers are in place at both ends of the hose.

Uses 15mm copper or stainless steel pipe. Do not use jointing compound ; use PTFE tape if needed. 📋 Installation Sequence

If the water flow drops over time, the internal inlet filter may be blocked: Isolate both the electrical and water supplies. Remove the front cover.

Remove the front cover of the Galaxy Aqua Premier by unscrewing the retaining screws at the bottom. galaxy aqua premier installation manual

: He connected the 15mm copper pipe to the inlet elbow. "No jointing compound," the manual whispered—only PTFE tape if things got difficult. Before the final connection, he flushed the pipe to clear out debris that could clog the internal filters.

Drill a small hole in the pipe and install the securely, ensuring the clamp is tight.

Peel the backing off the adhesive foam square and stick it over the drilled hole, aligning the openings. Connect the shower head to the hose

Every 6 months. Protects the system from dirt, rust, and scale.

Attach the shower hose to the unit's outlet, but leave the shower head off for now. Direct the hose into the tray or bath.

Apply 4 to 5 wraps of Teflon tape clockwise onto all male threaded fittings. Install the inlet and outlet adapter valves onto your existing plumbing lines. Ensure the arrows on the valves match the direction of the water flow (Inlet = supply side, Outlet = faucet side). Step 4: Hang the Main Unit Do not use jointing compound ; use PTFE tape if needed

Tighten the screws evenly on both sides until the clamp fits snugly around the pipe. Step 3: Mount the Faucet

What (e.g., 3-stage, 4-stage, or Reverse Osmosis) is your system?