Usb Vid 1f3a&pid Efe8&rev 02 3 Driver -

An Allwinner-powered consumer device connected to your PC experienced a software crash or firmware corruption. Lacking bootable firmware, the SoC automatically defaulted to its fallback hardware recovery state (FEL mode) to await instructions, causing your PC to suddenly detect an unknown VID_1F3A&PID_EFE8 device.

Windows does not ship with native support for raw SoC flashing interfaces. The primary drivers that utilize this specific ID are the or the bundled drivers found inside Livesuit , PhoenixSuit , or PhoenixCard —the official firmware flashing tools provided by Allwinner.

According to the USB ID Repository, the VID 1f3a belongs to , a Chinese semiconductor company widely known for its ARM-based SoCs found in countless low-cost tablets, TV boxes, e-readers, and embedded development boards. The PID efe8 does not correspond to a normal operating mode; it identifies the device when it has entered FEL mode — a factory boot mode built into Allwinner chips that acts as a last-resort recovery interface.

If you have found an unknown device in your Device Manager with the Hardware ID USB\VID_1F3A&PID_EFE8&REV_02 , you are likely working with a device based on the architecture. Specifically, this ID is almost exclusively associated with Allwinner A-series SoCs (like the A33 or A13) entering FEL Mode . usb vid 1f3a&pid efe8&rev 02 3 driver

sudo pacman -S sunxi-tools

[Device Manager] └── [Right-Click Unknown Device] └── [Update Driver] └── [Browse My Computer] └── [Have Disk...] ➡️ Select 'aw_usb.inf' Step 3: Bypass Driver Signature Enforcement (If Required)

Find the device marked with a yellow exclamation mark (usually under "Other devices" or "Universal Serial Bus controllers"). Right-click it and select Update driver "Browse my computer for drivers" An Allwinner-powered consumer device connected to your PC

ZTE does not always offer direct consumer downloads, but their generic "ZTE USB Modem Driver" package (often version 2.0.0.8 or higher) supports the 1F3A vendor ID.

What specific or tablet are you trying to flash? If you are running into error messages during the process, let me know the software tool you are using so I can guide you through the exact setup steps. Share public link

Choose Let me pick from a list of available drivers on my computer . The primary drivers that utilize this specific ID

Some versions of PhoenixSuit also provide the driver as a standalone package, so even if you do not need the full flashing tool, you can install just the driver component.

Some users report that LiveSuit works better with driver signature enforcement disabled on Windows 10/11. To test this, restart Windows with the “Disable Driver Signature Enforcement” option (Shift + Restart → Troubleshoot → Advanced Options → Startup Settings → Restart → select option 7).