Extra Quality !!hot!! - Sc67310 Ricoh Error

Ensure that the original job that caused the error is deleted from the server or computer to prevent the error from looping. Conclusion

— If you saw this phrase in an online review for a Ricoh repair service or part seller, treat it with caution. No genuine technical documentation uses "extra quality" with an SC code. It may be an auto-generated or spam review.

Before attempting any advanced settings, shut down the device properly. Turn the main power switch OFF, unplug the power cord from the wall outlet, and wait for at least 30 seconds. During this time, the residual electricity in the controller board will drain.

This error is not limited to a single machine. Users have reported this code across various series, including but not limited to the , the MP C3004, C3504, C4504, C5504, C6604 families, as well as production units like the Pro C5300, C5310, and C7200S models.

The is essentially a temporary disruption in communication between the screen and the engine, often exacerbated by the high-data demand of "extra quality" printing. While a simple reboot can solve the issue, frequent occurrences suggest the need for a firmware update or a check of the SP communication settings. sc67310 ricoh error extra quality

Replace the operation panel assembly or the panel control board.

Replace the (PN: D1475113). When replacing:

After IPU replacement, print a (SP2-194-001) and calibrate using the scanner or a spectrophotometer (if equipped) to restore "extra quality" mode.

Find setting (or similar "Flair" / Smart Panel communication toggles depending on the exact model). Ensure this parameter is enabled or active. Exit Service Mode and reboot the system. 4. Component Isolation (Advanced) Ensure that the original job that caused the

Turn off the primary power switch located on the side or back of the machine. Unplug the power cord entirely from the wall outlet.

The code specifically indicates a "Smart Operation Panel Communication Error" (Flair Communication Error) . SC Code: 673-10

: Outdated or corrupted firmware can cause "extra quality" processing tasks to hang, triggering a system timeout.

Plug the cable securely back into the wall and turn the machine on. 2. Verify the Operation Panel Physical Connections It may be an auto-generated or spam review

After the error is gone, print:

The main controller is busy or failed to respond to a notification from the panel.

is a software/firmware-related controller error . It typically indicates a communication failure between the controller board and the operation panel (or the engine). Common causes include:

Disclaimer: Some solutions require entering the Ricoh Service Mode (SP Mode), which should be handled by a qualified technician to avoid voiding warranties or causing further damage. If you'd like, I can provide: