V2000-c Rfid Access Control User Manual ((exclusive)) Instant
Standard 125 kHz (EM or compatible ID cards/fobs). Reading Distance: 3 to 6 cm. Operating Voltage: 12V DC ± 10%. Current Draw: < 60mA. Lock Output Load: Max 3A. Bell Output Load: Max 50mA.
The back of the V2000-C features a wiring block. Correct wiring prevents short circuits and equipment damage. Wire Color / Label Description Power Positive Connects to 12V DC positive power supply GND Power Negative Connects to power supply ground PUSH Low-level Trigger Connects to exit button or power supply push terminal OPEN Door Button Connects to one side of the exit button NC Normally Closed Connects to the positive side of a Magnetic Lock NO Normally Open Connects to the positive side of an Electric Strike COM Common Terminal
The Green LED will turn solid or flash to indicate active programming mode. Step 2: Modifying the Default Admin Code
A: No. The reader hardware is specific to one frequency. Check your model: V2000-c-EM (125kHz) or V2000-c-MF (13.56MHz Mifare). V2000-c Rfid Access Control User Manual
The V2000-c is a “set and forget” device, but proactive maintenance extends its life.
Caution: This action deletes all saved user cards and PIN data permanently. 5. Advanced Settings and Security Features Tamper Alarm Function
Do you need a specific for a dual-door system? Standard 125 kHz (EM or compatible ID cards/fobs)
Note: Always install the included diode across the lock terminals (in parallel) to absorb back-EMF surges and protect the keypad relay. 3. Programming and Configuration
Press 41 followed by # . Password Only Mode: Press 42 followed by # . 4. User Account Management (Adding & Deleting Users)
If the Master Code is lost, reset the device manually using the hardware pins. Power off the V2000-C unit completely. Current Draw: The back of the V2000-C features
If you forget the Master Code or experience configuration errors, perform a hard factory reset. the V2000-C unit.
Issue 2: Card reads successfully (beep heard), but the door does not open