Remington Rand 1911a1 Markings !!link!! -

Its markings are the primary "fingerprints" collectors use to trace the history and authenticity of these legendary firearms. The Slide: Identifying the Three Versions

Fake Remington Rand markings fall into two categories:

Remington Rand 1911A1 markings

Correct for the vast majority of Remington Rand production. Springfield Armory (Early Production)

A folded photograph slid from between the grips, thin and yellowed. On it, a man in uniform—hat brim low—smiled with a cigarette-not quite proud, not quite at ease—next to a jeep with muddy tires. The writing on the back read: “To Mary, keep this till I’m back. R.” The name matched the faint cartouche on the frame, the single letter an echo across decades. remington rand 1911a1 markings

The frame carries the critical indicators of military acceptance and manufacturer identity:

: Stamped forward of the slide stop pin hole.

The Remington Rand 1911A1 is highly sought after by collectors and enthusiasts due to its historical significance and unique markings. When collecting Remington Rand 1911A1 pistols, it's essential to look for the following:

On the right side of the frame, you will see UNITED STATES PROPERTY and the designation M 1911 A1 U.S. ARMY . Its markings are the primary "fingerprints" collectors use

Remington Rand produced the largest number of 1911A1 pistols during WWII, and their markings evolved across three distinct production phases.

"M1911A1 U.S. ARMY" located forward of the slide stop pin.

Remington Rand serial numbers are uniquely preceded by a "NO" (with the 'O' slightly smaller or raised).

If you're interested in learning more about the Remington Rand 1911A1 and its markings, here are a few additional resources to check out: On it, a man in uniform—hat brim low—smiled

When you pick up a Remington Rand 1911A1, you’re not just holding a firearm—you’re holding a piece of wartime industrial history. Unlike the commercial-grade Colt pistols, Remington Rand’s markings tell a story of mass production, government contracts, and the subtle evolution of one of America’s most iconic sidearms.

Behind the right grip panel, you will find the —a small stamped wheel with crossed cannons. This stamp was applied after Parkerizing, meaning some bare metal should be visible within the stamping lines where the die broke through the finish. This is one of the most reliable indicators of an original finish.

Found on the right side of the frame, above the serial number. FJA Stamp:

Estimated production of Type I pistols runs between 10,000 and 15,000, with most falling in the serial number range of approximately . If you find a Type I, you have found something genuinely scarce.

The Remington Rand 1911A1 is a fascinating piece of American wartime history—a typewriter company that became the most prolific manufacturer of sidearms during World War II. Understanding its markings transforms a casual ownership experience into an appreciation of industrial history, quality control systems, and the men and women who built these weapons under immense pressure.