: You can download the PlotCalc plugin which supports the specifically for CorelDRAW. SignTools : If using SignTools 4 , you must select " Cutok DC330
* Software for CutOk DC330 plotter. * Added/Modified: 14.09.2025 (17:50:34) * Maximum width, mm: 280. * Commands Language: HPGL. * cutok dc330 drivers / System System Product Name
Navigate to Control Panel > Devices and Printers . You should see a printer named CUTOK DC330 . Right‑click this icon and select Printing Preferences . Click the Advanced button. Here, set the correct paper size:
The installer is corrupted or missing DLL files.
Изменение давления ножа Для изменения давления ножа во время работы или передачи данных с компьютера Вы можете нажать кнопку или .
Try a different USB port on your computer, preferably one directly on the motherboard (rear port) rather than a front-panel port or hub. "Printer Not Found" Error: Reinstall the USB-SERIAL driver.
Installing the Cutok DC330 driver installer is a straightforward process that can be completed in a few steps:
The USB cable might be loose or damaged. Swap to a different USB port directly on the computer motherboard (rear ports for desktops) instead of a USB hub. Re-run the driver installer. Issue 2: The Cutting Software Freezes When Sending a Job
: Always install the manufacturer's USB driver first before connecting the cutter to your PC. This creates a virtual necessary for communication. Configure the Port
Fix : This indicates a baud rate mismatch. Go to Device Manager > Ports > Right-click your COM Port > Properties > Port Settings. Ensure the bits per second matches your software settings (usually 9600 or 38400).
: Open the extracted folder, right-click on the setup.exe (or USBDriverInstaller.exe ) file, and select Run as administrator . Follow the Prompts : Click Next through the setup wizard.
Try a different USB port on your computer, ideally a USB 2.0 port rather than 3.0.
Set the Baud Rate typically to 9600 or 19200, depending on your specific manual’s instructions. Troubleshooting Common Issues If the machine still isn't responding, check the following:
Plug the USB cable into the Cutok DC330 and an open USB port on your PC. Plug in the power cable and turn on the cutter.
