Iwata 2crh Bundy Clock Manual Today
Built-in lithium battery keeps settings safe during power failures. Card Feed: Automatic feeding and alignment mechanism. 2. Initial Setup and Configuration
Switch the machine back to , replace the cover, and run a test print on a blank card. 🔍 Troubleshooting Guide Potential Cause Actionable Solution Clock will not accept timecards Main switch is left in setting mode. Move the program switch back to NORMAL . Clock will not accept timecards Timecard inserted backwards or upside down. Flip the card to match the current half of the month. Print color is incorrect Shift changes were programmed improperly.
Adjust where the stamp appears on the card.
: Select between different programming groups (e.g., b001, b002). 2. Basic Time & Date Settings
Accommodates up to three shifts per day (Morning In/Out, Afternoon In/Out, and Overtime In/Out). iwata 2crh bundy clock manual
The manual detailed the "Two-Color Printing" setting. Elias adjusted the small metal pins behind the clock face. These pins told the machine exactly when the workday began. Black Ink: Standard hours. Anything after 9:01 AM.
Press and hold the button for 3 seconds until the display flashes. Use the UP and DOWN arrows to cycle through setting codes.
The 2CRH uses a standard ink ribbon cartridge (similar to old dot matrix printers or typewriters).
A: The date mechanism is mechanical. Advance the time manually past midnight (11:59 PM to 12:00 AM) while watching the date wheel. If it doesn't flip, the date advance pawl is broken – a common repair documented in the service manual. Built-in lithium battery keeps settings safe during power
: Ensure employees use side A for the first half of the month (Days 1–15) and side B for the second half (Days 16–31). 🖨️ Maintenance: Replacing the Ribbon Cartridge
| Symptom | Likely Cause | Solution | |---------|--------------|----------| | Clock does not move | Dead mains, blown fuse, jammed gears | Check power, replace fuse (slow-blow), oil movement | | Prints faint / no print | Worn ribbon, dirty print wheels | Replace ribbon, clean type with isopropyl alcohol | | Always prints red | Color-change cam stuck, spring broken | Open movement, check cam follower near 12 o’clock wheel | | Prints wrong date | Manual date knob turned, or date wheel jam | Advance date to correct by turning only | | Card jams | Bent card guide, foreign object in slot | Remove debris, gently realign guide with pliers | | Does not print when card inserted | Micro-switch disconnected, solenoid dead | Check switch continuity, listen for solenoid click |
Slide the main setting switch from to Program (often labeled as shifting a switch to the right or left depending on the exact manufacturing batch). The LCD screen will flash, indicating it is ready to be programmed. Step 2: Setting the Year, Month, and Date The parameter code for the date is usually the first menu.
: Choose between 12-hour or 24-hour display modes. Initial Setup and Configuration Switch the machine back
Never force the internal gears. If you feel resistance while turning knobs, stop and check the mechanism.
Avoid mounting the Bundy clock in direct sunlight, high humidity (such as near open-air kitchens), or overly dusty factory floors.
Do not install the clock in areas with high humidity, direct sunlight, or heavy dust accumulation.
