: For high-risk applications or fatigue design over 16,000 cycles, refer to EN 13001-2 . 2. Mechanical Safety Requirements
The standard applies to a wide variety of "below-the-hook" lifting accessories, including: : Used for gripping and lifting steel plates.
Always purchase the official PDF from a recognized standards distributor. The cost is minimal compared to the potential consequences of non‑compliance or equipment failure.
Under EU law, placing lifting attachments on the market requires based on a technical file that includes proof of conformity with relevant harmonized standards. Auditors and notified bodies demand to see the actual standard, not a third-party summary. din en 13155 pdf
A: Only if the product title says "including Amendment A2:2016." Do not buy a file dated solely 2009.
Conformity with the standard is verified through two main routes: or testing .
The standard dictates specific structural safety coefficients to handle dynamic forces during acceleration and braking. : For high-risk applications or fatigue design over
You can acquire the full PDF or paper versions from authorized distributors: : Offers the DIN EN 13155:2025-11
The standard covers the following aspects:
DIN EN 13155 standard, titled "Cranes – Safety – Non-fixed load lifting attachments," Always purchase the official PDF from a recognized
Unlike standard crane components, non-fixed attachments can be directly attached or detached from a crane hook by the operator. Because these devices bridge the gap between the lifting machinery and the load itself, their structural integrity is critical to preventing catastrophic dropped-load accidents.
A revision process is expected around to align with the new Machinery Regulation (EU) 2023/1230, which replaces the old Machinery Directive. Key anticipated changes include:
One of the most critical technical aspects detailed within DIN EN 13155 is the categorization of stress and fatigue. Lifting attachments are rarely used for a single lift; they are subjected to thousands of cycles over their operational life. The standard provides detailed tables and formulas for "stress categories" and "mechanical stresses." It forces engineers to calculate the Working Load Limit (WLL) not just based on static weight, but on dynamic forces, impact factors, and the number of lifting cycles the device is expected to endure. By standardizing these calculations, the document ensures that a plate clamp rated for two tons in Germany performs with the same reliability and safety margin as one manufactured in France or Italy.
DIN EN 13155 is the German implementation of the harmonised European standard EN 13155. It specifically covers .