All other configuration settings, such as door control parameters and input/output mapping, are set within the OnGuard host software, not via physical switches or jumpers on the board.
Verify the RS-485 wiring polarity (A vs B). If using legacy M5 boards, ensure they are addressed correctly within OnGuard.
This updated post highlights the key steps, wiring diagrams, and configuration notes for the LNL-3300M5 – a dual-reader interface module for Lenel’s NetBox or OnGuard access control systems.
Supports up to 240,000 local badge holders. lenel lnl3300m5 installation manual upd top
Once the hardware is powered and wired, you must add it to the OnGuard interface: Open . Navigate to the Access Control tab and select Panels . Add a new panel and select LNL-3300 as the type. Enter the IP Address assigned to the controller.
4.56 in. W x 10.25 in. L x 0.8 in. H (115.8 mm x 260.4 mm x 20.3 mm). Required Cable Specifications
A successful installation begins with careful planning and strict adherence to safety guidelines. All other configuration settings, such as door control
The LNL-3300-M5 features an onboard 10/100 MB Ethernet port, removing the need for sluggish serial-to-Ethernet converters. It operates as an independent edge device, executing real-time access control decisions via its local memory database. Specification
Document every UPD address in your as-built drawings. Mismatched addresses are the #1 cause of “controller not seeing device.”
This section details the most critical step for system stability. This updated post highlights the key steps, wiring
[Insert date] Let me know if you need specific wiring pinouts or DIP switch tables!
Position the LNL-3300-M5 onto the existing standoffs. The form factor matches standard legacy footprints exactly.
platform. It serves as a direct, plug-compatible replacement for legacy CPUs (such as E, P, PX, or PXNplus) and power/comm boards, allowing for a "one-for-one" hardware swap without requiring new field wiring. Hitron Bina Teknolojileri Core Installation & Setup Installation of the LNL-3300-M5 is designed for high speed and minimal disruption: Hardware Migration
: The LNL-3300-M5 is plug-compatible with the 12 VDC power input, cabinet tamper, and AC power fail inputs from the legacy Power/Comm Board. Reconnect and Power Up
She printed the UPD_TOP manual and spread it out on the conference table. The manual read like a map of the controller’s soul: power requirements, jumper settings, termination resistors, firmware sequencing, and a stern warning about mixing firmware revisions. There were diagrams of backplanes, pinouts for Ethernet and serial ports, and a flowchart that, at a glance, made firmware updates seem like defusing an old-world bomb.
