The ADP-160ER schematic is used in a wide range of applications, including:
is a standard switch-mode power supply (SMPS) used specifically in the PlayStation 4 Slim (CUH-2100 series)
: Depending on the exact revision (like the ADP-160ER AAA ), some component markers or values might differ slightly from third-party aftermarket diagrams.
100V–240V ~ 2.5A, 50/60Hz (Universal worldwide compatibility) Adp-160er Schematic
If the input voltage reaches the bulk capacitor but there is no 4.8V output on Pin 1, the standby PWM controller or its startup resistor network is likely defective. Symptom 2: Blue Light of Death (BLOD) / Instant Click-Off
Converts the filtered AC voltage into pulsating DC voltage. 2. Primary Side (High Voltage)
Degraded optocouplers can send incorrect voltage information back to the primary controller. This causes the power supply to enter a continuous reboot loop, often manifesting as the infamous "Blue Light of Death" (BLOD) or a single beep followed by an immediate shutdown. Safety Warnings for Repair Technicians The ADP-160ER schematic is used in a wide
If the console has no standby light at all, the small 5V standby controller is often the culprit.
Form a low-pass filter to eliminate high-frequency line noise.
A 3.3V or 5V logic signal sent from the motherboard to wake the main 12V rail. Pin 4 (GND): Logic ground reference. Circuit Architecture Breakdown Safety Warnings for Repair Technicians If the console
Repair Tip: Schottky diodes are a common failure point. A shorted output diode will blow the primary fuse. Test them with a multimeter in diode mode.
A Schottky diode outputs a clean +4.8V DC standby voltage to the motherboard. 4. The Main Power Circuit (+12V Rail)